Bobbins black LV8 with protection

The productdescription on our webshop has been automatically translated. We apologize for any errors. You can always ask us questions in English.

Bobbins for in the swingarm of your LV8 motorcycle. These are made of aluminum and black anodised. The bobbins have a larger disc on the inside to prevent damage to your swingarm when jacking up with a paddock stand. Available in sizes M6 to M10. Check in advance what size screw fits you in the swingarm. The bobbins are supplied per 2 pieces.

Indication for sizes:

M6 x 1mm: Aprilia, Ducati, Yamaha

M8 x 1.25mm: Ducati, Honda, Kawasaki from 2013, Suzuki

M10 x 1.25mm: Husqvarna, Kawasaki before 2013, KTM

Note 1: the above sizes are indicative. Always check whether the size is correct for your own motorcycle (especially Kawasaki).
Note 2: KTM also has models with M10x1.5mm. If you need this variant, place this in the comment with your order!

Reviews (2)

9 average of 2 reviews
We guarantee the authenticity of the reviews because only customers who have actually bought the product can write a review.

by Cor Jxxxx (automatically translated from Dutch)

06/16/2021


For my 2007 ZX10R, the right side needs a washer so that the bobbin comes out a little further. Otherwise the bobbin will hit the rear fork. No problems and a good product.

by Kurt Vxx xxxxxxxxxxx (automatically translated from Dutch)

10/24/2018

Tankpad TUONO from MotoGrafix has an excellent finish in special 3D gel (does not yellow) and a beautiful design. It is a nice eye-catcher for your motorcycle, while it immediately protects the paint of the tank against scratches of your motorcycle pants or motorcycle jacket. Dimensions: height = 270mm / bounce = 170mm (widest point at the top) <h2> Install tankpad </h2> For a good sticking result (applies to each sticker) you must ensure that the room is at least 15 degrees and not damp (as often in the barn or garage). For example, if you put the tank down in your living room to warm up, leave it for at least 1 day as you initially get condensation and that takes a moment to evaporate. If the tank pad is stuck on a curvature, heat the tank suit with a fohne after sticking. Stick the corners if necessary with adhesive tape for 24 hours, so that the glue gets the chance to attach well. Remove this tape after 24 hours. Do you have to let go of corners, make a clear photo and email us with the issue. Never pull off the tank pad, because then it can no longer be used. 

Applied / used on: Yamaha MT-10 bouwjaar niet aangegeven - Diameter: M6

Bobbins black LV8 with protection

Bobbins black LV8 with protection

Bobbins black LV8 with protection is avaibable with the following options:

Reviews (2)